Details required :. Cancel Submit. Ray Hipkiss. How satisfied are you with this reply? Thanks for your feedback, it helps us improve the site. I dont think there is any more powerfull battery that woudnt brake the phone. Since more electric power might brake phones hardware. You should buy portable charger Nokia has one for one full charge other portable charghes are more powerfull but not so portable.
In reply to Tahvo's post on December 18, You're kidding, right? No higher current battery will harm a phone, unless the battery has a physical problem. Basic laws of electronics there.. This is why I have already replaced the battery on my own already.
My Nokia n8 is now one year old and am talking about battery! Shame on u nokia. Nokia has problem with the battery capacity the last years. They should build phones with higher capacities batteries.
I cant use any of the Nokia N phones that i have for more than 8 hours continue. Always get total empty after the 8hours. I think thats why the name of the phone is N8. Only 8 hours can i use it after that is dead and need charge again. Nokia must do something by building 2. Try setting a world record. Utilizing the front facing camera, apps such as Fring or Skype enable users to video chat anywhere they like with mobile-to-mobile as well as mobile-to-desktop connections.
Hey look at that -- visible T4 Torx screws! We figured this was a good place to start to take it apart. A trifle later the bottom portion of the phone was off. If we only had one of these After the bottom cover of the phone is removed, a small battery retaining bracket can be popped out of its socket. Although it requires the removal of two odd-sized screws, the battery really isn't that hard to replace.
Thumbs up for no soldering! The BL-4D 3. Sure Nokia, sure The hologram stuck under the battery's pull tab is most likely there to ensure you're getting an actual Nokia-approved battery and not some low quality clone. The digitizer and display cables still attach the front panel to the rest of the phone, so be sure to lift the display assembly from its top edge if you decide to open your unit. Thankfully the glass is not fused to the face of the AMOLED display, so you don't have to replace both if just the glass breaks.
The silk screen also indicates the display was manufactured February 2, This thing has been around for quite some time. The touch screen controller is a Synaptics TA. A couple T6 Torx screws and the upper antenna hold the mid-plane to the inside of the N8. Nokia got pretty creative with their antenna placement, as this device is primarily encased in aluminum.
The main antennas are located near the flat plastic plates on the top and bottom of the phone, as seen in the second and third pictures. After removing the screws and popping off the antenna, the mid-plane can be removed from the N8. The design of the steel mid-plane is pretty genius.
Nokia integrated a large EMI shield into the mid-plane to protect the main chips. In addition, thermal pads were placed on the inner face of the mid-plane to conduct heat away from the main chips. As processor speeds increase and devices become more integrated, the need for thermal management becomes critical to ensure longevity and operability in many environments. After the mid-plane is removed, the motherboard can be simply lifted out of the rear case.
The daughter board at the top of the motherboard has an interesting design in that it is connected to the main motherboard via a ribbon cable that is sandwiched between the many layers of the motherboard. On most devices, ribbon cables are attached with ZIF connectors or are soldered to the surface of the board, not sandwiched between layers.
As opposed to many other smartphones that use either a single or double LED for the flash, the N8 uses a Xenon flash tube similar to the kind of flash found in full-size cameras. The large capacitor on the flash module supplies the high voltage necessary to produce such a brilliant flash.
The loudspeaker can be pried off the adhesive securing it to the rear case at this point. This loudspeaker is primarily used for speaker phone as well as for playing audio from media stored on the phone. The battery, although considered by Nokia not to be user-serviceable, can be easily removed. The AMOLED display easily comes apart from the glass, which means that you can replace the glass and the display independently.
You still have to use a heat gun to remove the front glass, but at least you're heating up metal that won't deform as easily as plastic. Removing the cameras is near-impossible, and requires tedious, potentially detrimental steps. Badges:
0コメント